Turbo And Oil Cooling Lines Dsmtuners White, factory water coolant feed for the 2g oil cooler (edit: or 1g 91 94 dsm), plug it or run a hose from it to the red colored fitting on the th. again, mixed up. purple is the turbo coolant return line and white is the '91 oil cooler return. brian. Turbo coolant and oil lines. thread starter racer009; start date may 15, 2010; dsmtuners is the largest dsm forum and online enthusiast community on the web.
Oil To Turbo Coolant Lines Question 4g64 Block Dsmtuners I need a new set of turbo and oil coolant lines and when i went to the dealer the parts guy was clueless. does anyone have part numbers for the turbo oil and coolant feed and return lines? thanks in advance. The 14b 16g is pretty much a bolt on for the 1g auto too. i installed a ported 14b on my car. i used the oil coolant lines from my 13g. you do have to get the bigger eyebolts from a 14b. then the oil feed, and coolant lines have to be drilled out to fit the new eyebolts. i work at a machine shop, so it was a 5 minute affair for me to do this. The bottom line of the turbo on all dsms is an oil drain to the pan. a 91 94 1g turbo thermostat housing has a coolant feed from the thermostat housing to the turbo and a coolant feed from the thermostat housing to the oil cooler. you must be logged in to view this image or video. 1990 coolant hose routing (with external air oil cooler). Turbo oil feed line you will need a 4an feed line to properly feed oil to your holset. with my setup, i do not need any restrictor. you can also use an in line filter in your feed line. my turbo came with a feed line fitting at the turbo so i bought the line and the fitting at the ofh individually. my cost $25.00 from extreme psi.
Oil Coolant Lines And Tranny Cooler Dsmtuners The bottom line of the turbo on all dsms is an oil drain to the pan. a 91 94 1g turbo thermostat housing has a coolant feed from the thermostat housing to the turbo and a coolant feed from the thermostat housing to the oil cooler. you must be logged in to view this image or video. 1990 coolant hose routing (with external air oil cooler). Turbo oil feed line you will need a 4an feed line to properly feed oil to your holset. with my setup, i do not need any restrictor. you can also use an in line filter in your feed line. my turbo came with a feed line fitting at the turbo so i bought the line and the fitting at the ofh individually. my cost $25.00 from extreme psi. I've read a bunch of dsmtuners threads about t28s, but most are old or go off topic fast edit: i already have a 3" exhaust, hard intercooler pipes, 1g bov, walbro 190 and general maintenance is up to date. The turbo’s water lines should be plumbed into the engine’s existing cooling system, and can be teed off of the heater lines if they are still present in the vehicle and convenient. engine coolant (antifreeze) can be used without worry – water cooled garrett turbochargers are qualified during heat soak back testing using a typical 50 50.
2g Block Coolant Line Dsmtuners I've read a bunch of dsmtuners threads about t28s, but most are old or go off topic fast edit: i already have a 3" exhaust, hard intercooler pipes, 1g bov, walbro 190 and general maintenance is up to date. The turbo’s water lines should be plumbed into the engine’s existing cooling system, and can be teed off of the heater lines if they are still present in the vehicle and convenient. engine coolant (antifreeze) can be used without worry – water cooled garrett turbochargers are qualified during heat soak back testing using a typical 50 50.
Comments are closed.