Shower Diverter Valve Removal At Matilda Eiler Blog To repair the diverter knob, remove the cover or set screw with an allen key or screwdriver. replace the handle and tighten the screw securely. if the cartridge needs replacing, remove the handle and trim plate first. use pliers or a special tool to swap out the cartridge. this ensures a working shower diverter. I show how to remove an old shower diverter valve and install a replacement. i also walk through applying ptfe tape to ensure more water tight seals to preve.
How To Fix A Shower Diverter Value A Diy Repair Guide Clean the valve opening. before installing the new shower diverter valve, clean the inside of the shower diverter valve opening using a rag dipped in vinegar. apply faucet grease on the seat washer and the 2 o rings. push in the new valve and screw it in until hand tight. tighten it further with the socket wrench. Screw the tub faucet back onto the threads, then replace the set screw (if you removed one). be careful not to overtighten the spout. you want it flush with the tile and pointing straight into the tub. turn the water supply back on and check for leaks around the tub spout or diverter. First, the tub faucet handle and decor plate must be unscrewed. they are located on the front side of the tub faucet. now, insert a screwdriver into the hole located on the end of the handle. then turn the screwdriver counterclockwise until the set screw is loose. simply lift the handle down and twist the decor plate off. Follow this seven step guide to replace your broken shower diverter: 1. locate the shower shut off valve to turn off the water. it may be behind an access panel near your shower or in your basement. 2. cover or seal your drain with tape. you don’t want small hardware falling down the drain! 3.
Comments are closed.