How To Change A Thermostat Mk4 Golf Tdi Youtube In this video you will see how to change a thermostat on a mk4 golf tdi pd130, or any pd for that matter, whether it be audi, skoda etc you will also see. In this video, i show how to remove and replace the thermostat in my 2001 vw golf tdi with the 1.9l alh engine. i decided to replace this because my temperat.
Mk4 Golf Gt Tdi Pd130 Thermostat Replacement Mk2 Golf Youtube A lot of guides to show how to replace the thermostat on a vw tdi engine say that you need to remove the alternator to get access. this video shows how to do. Remove the hose clamp from the lower radiator hose at the thermostat flange. this is just underneath the fuel injection pump. remove the 2 bolts holding the thermostat flange to the block, 5mm allen bit on about a 6 inch ratchet extension. cover the alternator with foil or a plastic bag to avoid coolant spilling on it. Like everyone says: 1. use genuine parts, 2. clip new thermostat into new housing with new o ring. 3. have no regrets. i like the idea of trying to pull the old thermostat out by the loop and bring the housing with it without breaking clips and save for a spare if possible, but, best to have new housing on hand. o. Thermostat replacement must be done on a cold engine only. do not attempt to replace the thermostat on a hot engine. first, remove the engine cover held on by 3 10mm nuts. the thermostat is located below the injection pump. remove the coolant hose and bend it upwards to prevent coolant from leaking out. the thermostat will be closed so coolant.
Vw Golf Mk4 Tdi Alh Thermostat Removal And Install Youtube Like everyone says: 1. use genuine parts, 2. clip new thermostat into new housing with new o ring. 3. have no regrets. i like the idea of trying to pull the old thermostat out by the loop and bring the housing with it without breaking clips and save for a spare if possible, but, best to have new housing on hand. o. Thermostat replacement must be done on a cold engine only. do not attempt to replace the thermostat on a hot engine. first, remove the engine cover held on by 3 10mm nuts. the thermostat is located below the injection pump. remove the coolant hose and bend it upwards to prevent coolant from leaking out. the thermostat will be closed so coolant. Use a series of extensions and universal joints to remove the bolts. pull the housing off the motor and you can get access to the thermostat. remove the old thermostat and install the new one. make sure that the rubber o ring goes on the outside of the thermostat between it and the housing. Some of the most common symptoms of a bad thermostat are no heat, a spiked temp gauge, a blown head gasket, and more. a thermostat failure can only happen in two ways. the thermostat stays in the closed position and won’t let coolant through when the engine reaches operating temperature. or, the thermostat will stay open, and the coolant will.
Comments are closed.