Honeywell Home Rth7600d Installation Manual 0300 manual auto changeover press s t to select manual or automatic changeover: 0 manual changeover (heat cool off). 1 automatic changeover (heat cool auto off). automatically turns on heat or cool based on room temperature. note: system maintains minimum 3°f difference between heat and cool settings. 0320 temperature format (°f °c). Set to the time you leave home and the temperature you want while you are away (usually an energy saving level). set to the time you return home and the temperature you want during the evening, until bedtime. set to the time you go to bed and the temperature you want overnight (usually an energy saving level). 6:00 am 70 ° leave 8:00 am 62.
Honeywell Home Rth7600d Installation Manual Operating manual 69 2207es—05 16 reset next done m27536 60 days reset schedule clock & mode m27535 system fan auto set to heat on change filter 70 6:01 am 70 heat if activated during installation, the furnace filter reminder alerts you when it is time to replace your filter. press reset after changing the filter, to restart the timer. Description. in most houses, installing a honeywell rth7600 thermostat is a simple task that takes up to 30 minutes. step by step instructions are described in installation instructions and simplify the installation and wiring of the touchscreen programmable thermostat (rth7600d, rth7600d1030), so use this document as your basic guide on 30 pages in english. Advanced installation guide about your new thermostat wiring—heat pump connect wires: heat pump 1. match each labeled wire with same letter on new thermostat. 2. use a screwdriver to loosen screws, insert wires into hole, then tighten screws. 3. Page 15: system setup. about your new thermostat system setup step 1 press system & fan. 0120 system & fan schedule step 2 press and hold the center key until the screen changes (approximately 5 seconds). 0120 system clock & more done rth 600 m27522 m27523 69 2206ef—01.
Comments are closed.